I Tracked Two Years of Safety Eyewear Purchases. The Cheapest Pairs Cost Us the Most.
A warehouse EHS manager breaks down two years of PPE spend data and argues that buying safety glasses on unit price alone is the most expensive mistake a procurement team can make.
The $1.80 Safety Glasses Nobody Wanted to Wear
Buying safety glasses on unit price alone is the most expensive routine mistake in PPE procurement. I know because I made it for 18 months straight.
When I took over EHS at our 340-person distribution center in early 2022, the previous manager had left behind a spreadsheet and a habit. The spreadsheet listed our approved eyewear suppliers. The habit was to reorder whichever SKU had the lowest per-pair cost on the quote sheet that week. Fifty cents cheaper than last quarter? Switch. Done. Nobody asked where the glasses went, just how much they cost.
I ran with that habit for a year because, honestly, the numbers looked fine. We were spending roughly $4,100 a year on safety glasses for a facility where about 210 people needed them daily. That works out to under $20 per person per year on eye protection. My boss loved that number. I loved that number. Then in Q1 2023 the same pair of complaints started piling up, and I finally did the math I should have done in month one.
The cheap pairs weren't saving us money. They were just moving the cost somewhere I wasn't tracking.
What Two Years of Purchase Data Actually Showed
Let me lay out what I found when I pulled 24 months of invoices and cross-referenced them against our request log and compliance audit notes.
In 2022, buying on unit price, we purchased 4,880 pairs of safety glasses across four vendors. Average cost: $0.84 per pair on the low end, up to about $2.10 depending on the batch. Total: just over $4,100.
In 2023, after we switched to a standardized lineup and stopped chasing unit price, we purchased 1,760 pairs. Average cost was higher, around $7 to $9 per pair depending on the model. Total: just over $9,400.
On the face of it, we spent more than double. Here's the part the invoice doesn't show.
In 2022, we filed 11 near-miss reports where the root cause was "employee removed eyewear due to discomfort or fogging." Four of those happened in the wet chemical handling bay, where we also have a wet chemical fire extinguisher posted, and the audited corrective actions required additional training hours. We spent about 38 hours of staff time that year just re-training, re-issuing, and documenting. At a fully loaded cost of roughly $31/hour, that's $1,178 of internal labor the unit price never accounted for.
We also had two OSHA recordable incidents in 2022 that required medical evaluation. Neither led to a citation, but both led to a week of paperwork, an adjuster visit, and a very uncomfortable conversation with our insurance carrier.
And then there's the disposal. In 2022 I counted—yes, actually counted one week—how many pairs got thrown away because the lens was scratched beyond use within 10 days of issue. It was 61 in a facility of 210 daily wearers. That's a roughly 29% effective replacement rate per week, on a product we were buying specifically to reduce replacement cost.
After the switch in 2023, our weekly scratch-and-toss count dropped to 14. Same work environment. Same worker population. Roughly the same tasks being performed. The difference was that the lenses were polycarbonate lenses with a proper hard coat, they actually fit, and—this matters more than anyone wants to admit—people wanted to keep them on.
The Real Reason Cheap Eyewear Costs More
Most buyers focus on the per-pair price and completely miss the wearability factor, which is the single biggest driver of whether your eyewear program works at all.
Here's the uncomfortable logic. A pair of safety glasses only protects the wearer while it's on their face. Every dollar you save on the pair is a dollar spent on reducing the chance that it stays on. Cheap glasses don't fit as well, fog faster, scratch sooner, and—and I say this as someone who has personally surveyed dozens of exit interviews about why PPE comes off—they simply feel worse on the face for eight hours.
According to OSHA 29 CFR 1910.133, employers must ensure each affected employee uses appropriate eye protection. "Ensure" is the operative word. You cannot ensure compliance with a pair of glasses that a forklift operator pulls off every 40 minutes because it's fogging up in a cool aisle after leaving a warm dock bay.
And ANSI/ISEA Z87.1-2020, which is the consensus standard most safety eyewear is tested against, is a minimum baseline. It doesn't test for long-term comfort, anti-fog performance under temperature shifts, or how quickly a lens degrades under a normal warehouse cleaning routine. Those are the exact variables that determine whether your employee wears the thing.
This is what I keep coming back to: the per-unit price on the quote sheet is the number the buyer sees, and the wearability of the product is the number the compliance auditor eventually sees. They are not the same number.
The Optical Quality Problem Nobody Talks About
Here's the part I genuinely didn't understand until I talked to a lens engineer at a trade show in September 2023.
Not all polycarbonate lenses are ground and coated the same way. Cheap lenses are molded fast, often with visible distortion at the edges and no real anti-fog coating—what they have is a surface treatment that wears off after a few cleanings. If you wear them across a warehouse floor all day, that distortion is often described by workers as "makes me a little tired" or "gives me a headache by two o'clock." No worker is going to file a formal complaint about eyestrain. They're just going to time their removal to moment their supervisor looks away.
When we standardized in 2023, we tested four models with a small pilot group of 30 workers over six weeks. We ended up going with a mix—Edge Eyewear's Brazeau safety goggle for the chemical handling and washdown areas, and their Reclus frame for general warehouse use, mostly because the wraparound coverage and the available anti-fog coating held up better in our temperature-shifting environment than anything else we pilot-tested. The logo on the temple—that Edge eyewear logo—is honestly the least interesting thing about them. The interesting thing is that after the pilot group switched, the complaints stopped. Not decreased. Stopped.
This is what I mean about cost. The $1.80 pair had a hidden cost in eyestrain-related productivity drag that I can't precisely quantify, but I can tell you it doesn't show up on any invoice, and it definitely costs more than the $6 spread per pair.
"But Our Workers Lose Everything Anyway"
I get this objection because I used to make it. The classic line was: "What's the point of buying a $9 pair of glasses when a guy is going to lose them in his truck in three weeks?"
To be fair, in 2022, that argument had some real data behind it. We issued a lot of replacement pairs because people lost them.
But here's what changed when we brought in the better product: the loss rate dropped almost in half. Not because we hired different people. Because when employees view the eyewear as a piece of equipment they actually want, they tend to treat it that way. The same crew that was losing three pairs a year suddenly started using the temple strap we started stocking at the same time, and people started keeping their glasses in the case instead of on the dash of their truck.
I'd be lying if I told you I can prove causal direction on the loss-rate drop—some of it was probably the case and the strap doing the work. But the pattern held across our whole crew, and it held for two consecutive quarters. Take that for what it's worth.
I'd also point out this is the same logic we already accept everywhere else in procurement. Nobody at my facility would argue for buying the cheapest work boots on the market for a crew that's walking 12,000 steps a day—yet warehouse procurement teams will buy brown work boots on lowest bid every single time and then wonder why there's a boot replacement spiral. The exact same logic applies to safety glasses, hearing protection, gloves. It applies to the loop earplugs people ask me about when they see a worker with the little blue loop shape in their ears and assume they're just fancy—they're not necessarily better than a $0.40 foam plug, but they're better if the wearer actually keeps them in.
What I'd Look at Instead of the Unit Price
If I were rebuilding our eyewear program from scratch tomorrow, here's the checklist I'd use. It's the check I now keep taped to the inside of my procurement folder.
- Model the 12-month replacement rate, not the per-pair price. Take your five most likely models and ask each vendor for a realistic expected lifecycle under your specific environment. Multiply by your daily wearer count. That gives you a truer annual cost than the quote sheet does.
- Pilot-test comfort, not specs. Set up a 30-person, six-week pilot and ask two things: what's your honest removal count per shift, and what's causing it. That's your compliance number and nobody's brochure will give it to you.
- Check the anti-fog performance under your actual conditions. If your dock bay and your cool aisle have a temperature differential, run the test in that differential. A lake in a lab is not a warehouse.
- Budget the internal labor separately. Retraining hours, audit documentation, corrective action paperwork. All of that is real money and none of it appears in the PO.
- Standardize the lineup, not the SKU. One product for the general floor, one for chemical handling, one for wet environments. This lets your safety manager actually teach the program instead of issuing a different model every quarter because someone found a new low bid.
None of this is glamorous. None of it makes for a flashy procurement victory slide. But it's the difference between an eyewear program that protects people and one that just satisfies the invoice.
Let me close with the thing I'd want a skeptical reader to hear. I'm not arguing that price doesn't matter—it absolutely does, and I have a budget to defend like anyone else. What I'm arguing is that unit price is the only number in the decision that's cheap to see, which is why so many buyers anchor to it, and why so many of us learn the hard way that it's the least useful number in the file.
The $1.80 glasses were the most expensive thing I ever bought. I just didn't know it until I stopped looking at the invoice and started counting the hidden lines next to it.